Aftermarket 5.25 in. Rubber Rear Bump Stops for 5th Gen Toyota 4Runner (2010-2023)

DuroBumps premium bump stops are proudly made in the USA from dual durometer (hardness) rubber, providing smooth, progressive dampening that greatly reduces hard bottom-outs, allowing for greater control and comfort compared to OEM bump stops, which can feel rock-hard on contact. DuroBumps bring better off-road control and comfort compared to OEM bump stops and eliminate the “shell-shock” effect when hitting larger bumps.

Installing the DuroBumps DBR525LT is the equivalent of using a 3 in. block spacer with OEM bump stops. The DBR525LT limits wheel-up travel by 3 in. compared to OEM bump stops and is designed for Dobinsons OR Metaltech rear Long Travel Kits using a 12 in. rear shock only.

FITMENT DETAILS:

• Vehicle Fitment: 2010-2023 (5th Gen) Toyota 4Runner
• Size: 5 x 3 x 5.25 in. (ea.)
• Intended shock length: Dobinsons OR Metaltech rear Long Travel Kits using 12 in. rear shock only
• Lift Height: 2 in. plus (loaded)
• Deflection (compression): 1 in. @ 1500LBS

KEY FEATURES:

• Improved handling – Dual durometer rubber allows DuroBumps to act as a secondary coil spring, with smooth engagement that progressively increases compression load in a predictable fashion.
• Mounts in OEM location – Easily bolts into the OEM location to ensure a proper fit with no modifications.
• Reduced tire rub – Reduced wheel-up travel means less tire rub in the wheel wells and reduced driveshaft contact on the OEM gas tank skid.
• Misalignment corrected – The rear OEM bump stops are not aligned properly to the rear axle from Toyota. OEM bump stops are actually misaligned by approximately 1 in. DuroBumps addresses this issue by designing the proper offset so DuroBumps contacts the rear axle tube centered as needed.
• Increased suspension life – DuroBumps greatly extends the service life of other suspension components by absorbing the shock load applied from suspension bottom-outs. They absorb the impact, saving your critical suspension components from excessive wear and extending service intervals to shocks, upper and lower control arm bushings, and panhard bar bushings.
• Small, compact, application-specific – Designed for specific truck models, No “universal-fit” spacers required. 
• Smooth and silent – Unlike Hydro bumps, DuroBumps are whisper quiet on contact.
• Premium bump stops – DuroBumps are proudly made in the USA from the highest quality raw materials.
• Provided mounting hardware – Every set of DuroBumps comes with JIS 10.9 zinc-coated hex head metric bolts and a single-use thread locker, to ensure a strong, secure fit.

ABOUT DUROBUMPS:

DuroBumps are proudly made in the USA with dual durometer (hardness) rubber, providing smooth, progressive dampening that greatly reduces hard bottom-outs and allows for greater control and comfort compared to OEM bump stops, which can feel rock-hard on contact. With DuroBumps, you’ll gain better off-road control and comfort compared to OEM bump stops and eliminate the “shell-shock” effect experienced when hitting larger bumps.