The DuroBumps DBR35 rear bump stops for the 2003-2009 Toyota 4Runner is designed to be slightly taller than OEM bump stops so it can compress under load to soften the impact just prior to the ultimate stop. The DBR35 will not limit your wheel-up travel compared to OEM bump stops. It’s intended for stock-height trucks and mild lifts up to 2” (fully loaded).

ABOUT DUROBUMPS:

DuroBumps are proudly made in the USA with dual durometer (hardness) rubber, providing smooth, progressive dampening that greatly reduces hard bottom-outs and allows for greater control and comfort compared to OEM bump stops, which can feel rock-hard on contact. With DuroBumps, you’ll gain better off-road control and comfort compared to OEM bump stops and eliminate the “shell-shock” effect experienced when hitting larger bumps.

FITMENT DETAILS:

• Vehicle Fitment: 2003-2009 Toyota 4Runner
• Lift & Shock Size: 0” – 3”+ (Non-Long Travel) (recommended for 9” rear shock, equivalent to OEM size bump stop)

KEY FEATURES:

• Improved handling – Dual durometer rubber allows DuroBumps to act as a secondary coil spring, with smooth engagement that progressively increases compression load in a predictable fashion
• Mounts in OEM location – Easily bolts into the OEM location to ensure a proper fit—no modifications needed
• Corrected misalignment – The OEM bump stops on the rear of Toyota trucks are not aligned properly to the rear axle. They are actually misaligned by about 1”. DuroBumps addresses this issue by incorporating the proper offset into our design so that DuroBumps contacts the rear axle tube centered as needed
• Increased suspension life – DuroBumps greatly extends the life of other suspension components by absorbing the shock load when the suspension bottoms out.
• DuroBumps absorb the impact, saving your critical suspension components from excessive wear and service intervals to the shocks, upper and lower control arm bushings, and panhard bar bushings
• Small, compact, application specific – Designed to fit specific truck models. No “universal fit” spacers required
• Smooth and silent – unlike Hydro bumps, DuroBumps are whisper quiet on contact
• Premium bump stops – DuroBumps are proudly made in the USA from the highest quality raw materials
• Provided mounting hardware – JIS 10.9 zinc-coated hex head metric bolts and single-use thread locker are provided with every set of DuroBumps, insuring a strong, secure fit

WHAT'S INCLUDED:

• (2) Two rear 3.5” Rear Durobumps
• (4) Four JIS 10.9 M8-1.25 x 40mm flange bolt
• (1) Single use medium thread locker